Компетентность и качество из моделизм на службе страсти

Slot.it SP21 Professional Extractor Press Увеличить
Slot.it

Slot.it SP21 Professional Extractor Press

: SP21

  • Twitter
  • Pinterest
  • Mail

42,90 €

Vous cumulez 42 points de fidelité
Votre panier totalisera 42 баллов qui pourront être convertis en bon de réduction pour un prochain achat.

Нет в наличии товара

Ce produit n'est actuellement plus disponible.
Souhaitez-vous être informé par e-mail de sa disponibilité ?

OK
Бесплатная доставка от 100€ покупки*

описание

Discontinued product, refer to the new reference replaced TL01.

The SLOT.IT extractor/press is made up of:

Main body (1) entirely made with anodized aluminium alloy designed to work with any slot electrical motor, from the most common short case to the more sophisticated, double long transmission shaft 4WD motors.
The main face was laser marked with a millimetre scale to easily control the insertion of the pinion.
Counter bushing (6) made of brass which, before using the tool, must be screwed onto the lower inside part of the main body.
The bushing has two very important functions:
- to centre the double shaft motor perfectly by means of the axle housing hole.
- to keep all those motors that are not equipped with the double shaft centred and, at the same time, safeguard the inner bush of those 'long can' motors motor that do not have an axle stub protruding from the can.
Special steel extraction plate (5) that fits in the relevant housing in the main body to extract the pinions. Besides being very resistant, this plate has a very thin eyelet located between the motor and the pinion: only 0.7 mm. This allows to extract also the pinions located very close
to the motor case without causing any damage to it.
Multifunction brass tool (2) which, depending on the operation to be performed, must be inserted in the main body with the plug (steel, interchangeable, Ø1.9mm in order not to damage the pinion hole) downwards, in case of the extractor, or the pinion housing downwards, in case of the press. The pinion housing for this element were designed to house pinions with a diameter ranging from 5.5mm to 7.5mm without damaging them.
The steel plug (3) is locked into the brass tool by means of an M3 grub screw (4).
Advancement screw (7) on whose upper part there is an ergonomic plastic knob (8), while the lower part is suitable to couple perfectly with the tool bevel, reduce friction and allow the press to operate perpendicularly without clearance.

Похожие материалы

Photos clients

Envoyer votre photo

    * Champs requis

     ou Annuler

    Chargement... Veuillez patienter.

    Chargement... Veuillez patienter.

    Votre photo a été ajouté et sera visible une fois approuvée par un modérateur

    Fermer

    Questions

    Si vous avez des interrogations concernant le produit, n’hésitez pas à poster ci-dessous. Connectez-vous à votre espace membre afin de pouvoir poster une question.

    Poser une question

    Aucune question n'a encore été posée sur ce produit. Be the first to ask a question about this product!

    Question about the product

    * Required fields
    Send

    The question has been correctly sent

    PayPal
    Maestro карта
    Visa карта
    Mastercard карта
    Slot Car-Union 2020 Все права защищены
    Slot Car-Union 2020Все права защищены