These are strips of thin black rubber which wrap around the Tyre Walls. Each is long enough to go around two lengths of tyre wall, making a Half Straight 175mm section long. These can either be with blocks of colour (red or blue) on the front or plain white or plain black. With these you can leave them plain or add logos to them.
These covers are based on the fact that F1 circuits often put a long strip of rubber like a conveyor belt around the tyres to spread the impact of a car running into them. Otherwise the sharp noses of modern F1 cars could strike in between two stacks of tyres and go through the tyre barrier to whatever was behind.
They have self adhesive backing with a paper cover which means they can be stuck on to the tyres as they are wrapped around and will just overlap enough to make a secure join at the back. For a more permanent effect a small amount of hot glue can be squeezed in between the tyres and the cover (even this can be removed however and the glue comes off the tyres relatively easily if you want to use bare tyres again).
Here is a picture of what you can do with this plain rubber. It can be made to look very realistic by adding studs to them. Some hot glue, a few small sharp tacks and a little pot of silver enamel paint can make a really good looking job of it.
Chargement... Veuillez patienter.
Votre photo a été ajouté et sera visible une fois approuvée par un modérateur
Si vous avez des interrogations concernant le produit, n’hésitez pas à poster ci-dessous. Connectez-vous à votre espace membre afin de pouvoir poster une question.
Aucune question n'a encore été posée sur ce produit. Sea el primero en hacer una consulta sobre este producto!
Pack of logo stickers
4 tables with bases
5 oil cans in plastic
Ref: W-Grid girl