€42.90
Tax included

You accumulate 1.26 € by buying this product

Definitively sold out

This product is definitely sold out and can no longer be ordered.

Description

Discontinued product, refer to the new reference replaced TL01.

The SLOT.IT extractor/press is made up of:

Main body (1) entirely made with anodized aluminium alloy designed to work with any slot electrical motor, from the most common short case to the more sophisticated, double long transmission shaft 4WD motors.
The main face was laser marked with a millimetre scale to easily control the insertion of the pinion.
Counter bushing (6) made of brass which, before using the tool, must be screwed onto the lower inside part of the main body.
The bushing has two very important functions:
- to centre the double shaft motor perfectly by means of the axle housing hole.
- to keep all those motors that are not equipped with the double shaft centred and, at the same time, safeguard the inner bush of those 'long can' motors motor that do not have an axle stub protruding from the can.
Special steel extraction plate (5) that fits in the relevant housing in the main body to extract the pinions. Besides being very resistant, this plate has a very thin eyelet located between the motor and the pinion: only 0.7 mm. This allows to extract also the pinions located very close
to the motor case without causing any damage to it.
Multifunction brass tool (2) which, depending on the operation to be performed, must be inserted in the main body with the plug (steel, interchangeable, Ø1.9mm in order not to damage the pinion hole) downwards, in case of the extractor, or the pinion housing downwards, in case of the press. The pinion housing for this element were designed to house pinions with a diameter ranging from 5.5mm to 7.5mm without damaging them.
The steel plug (3) is locked into the brass tool by means of an M3 grub screw (4).
Advancement screw (7) on whose upper part there is an ergonomic plastic knob (8), while the lower part is suitable to couple perfectly with the tool bevel, reduce friction and allow the press to operate perpendicularly without clearance.

Files attached

Pinion Press-Extractor Tool

Technical sheet

Product Upgrade

Out of stock

Slot.it SP28 Multifunction brass tool steel...
Réf : SP28
See more
€12.90

Out of stock

Slot.it SP38 Extraction pin for small shaft...
Réf : SP38
See more
€3.50

In stock

Slot.it TL01 Professional extractor press
Réf : TL01
See more
€52.90

Out of stock

Slot.it TL07 Steel plug Ø1.9mm for extractor...
Réf : TL07
See more
€3.70

Customers pictures

Questions

If you have any questions regarding the product, feel free to post below. Other consumers may also provide you with additional information. Log in to your member area in order to post or answer a question.

Ask a question

Aucune question n'a encore été posée sur ce produit. Be the first to ask a question about this product!

Customers who bought this product also bought

In stock

Slot.it CH07 Screw pickup for wooden track
Réf : CH07
See more
€4.70

Out of stock

Slot Track Scenics CfP10 Fixing clips for...
Réf : CfP10
See more
€5.50

In stock

Slot.it PI09 Inline Pinions 9 teeth Ø5,5mm x2
Réf : PI09
See more
€3.50

Out of stock

Slot.it GI28-BZ Crown 28 teeth Ø15,9mm Bronze
Réf : GI28-BZ
See more
€7.20